CLICK HERE: HARDENED PISTOL HOLDER INSTRUCTIONS
Hardened Pistol Case Holders for Fired Brass
L.E. Wilson Hardened Pistol Case Holders are engineered for fired, straight-walled pistol cases that have little to no body taper. Constructed much like a neck-sizing die, each holder positively captures the case for precise trimming. Because pistol brass is pressed into and driven out of the holder (rather than “bumped” like many rifle cases), the process can be slower, but it delivers very uniform case length for consistent, clean crimps.
Key Features
- Hardened holders designed specifically for fired pistol cases with minimal body taper
- Die-style capture aligns the case for accurate, repeatable trimming
- Extended body length protects the case mouth; counter-bored for cutter clearance
- Use with a light arbor press or mallet – cases are pressed in and then driven/pushed out
- Produces uniform case length for more consistent crimps
- Made in the USA
Stocked Calibers
.38 Special, .38 Super Auto, .357 Magnum, .44 Special, .44 Magnum, .40 S&W, .45 Auto, .45 Colt, and 10mm Auto.
How They’re Used
- Insert the fired case and press fully into the holder with a light arbor press or mallet.
- Trim the case using your L.E. Wilson Case Trimmer.
- Drive or push the case out of the holder after trimming.
- Verify length and crimp, expect repeatable, uniform results.
Looking for rifle options or other styles? See all Case Holders.