Q: What about a case holder for 5.7x28?
Because this case has a large variance in dimensions, we only offer that caliber as a special case holder. Pleases send in three cases in the condition in which you intend to trim them, along with your contact information so we can arrange payment. Please remember to pack your cases along with a note for your request. Thank you,
Q: Do you have a case holder for 350 legend?
A: Currently, we are working on adding in the .350 legend as a standard case holder. We have been collecting sample cases to set dimensions of the holder. This holder is available, but at this time please call to order.
Q: Which holder should I get for 7mm Rem Mag?
For the 7mm Rem Mag you will use part # CH-264WNM for Neck Sized Only Brass listed on drop down as 264/300/338 Win Mag 308 Norma..... As you can see this holder works for several calibers.
For the New Case Holder (New Brass and Full Length Sized Brass) Visit this page, https://lewilson.com/rifle-case-holders-new-case and select 264/300/338 Win Mag .... Part # NCH-264WN.
Hope that helps,
LE WILSON SUPPORT
Q: What case holder for trimming brass on 6.5 prc cases. Also other calibers will this holder fit?
For the 6.5/300 PRC Case Holder we make a specific holder, it is listed as
6.5/300 PRC - #CH-PRC on the drop down. Select either 6.5 or 30 caliber to see holder.
Q: Which case holder do I need for the 22 Creedmoor?
Since cases are held by body taper for our case trimmer, the 22 Creedmoor should use the same holder as the 6mm and 6.5 Creedmoor. We have a both a FIRED and a NEW CASE Holder for these calibers.
Q: How do I know which is for new or fired cases?
A: This page, Rifle Case Holders is for Standard and FIRED Case Holders. When you select your caliber on this page, you will be notified if there is also a NEW Case Holder available. NEW Case Holders can be found on this page.
If I use a full length sizing die but have it set to only bump the shoulder back a few thousandths should I be using the “new” or “fired” case holder with my trimmer?
A: If you are sizing the body of the case and bumping the shoulder back, that would be a New Case Holder. But, if you have a large oversize chamber and your sizing die is set up to do a minimal size, the spring back could make your cases act more like fired cases. So in calibers such as .308 Win or any AR platform, we usually recommend getting both FIRED and NEW Case Holders.
Q: Which holder would be right for the 454 casull?
A: The 454 Casull will use the 45 Colt Q-type Case Holder.
Q: I am looking for a case holder for .308 Marlin express. I did not see it listed. Which is right case holder for me?
The 308 Marlin Express will use the 308 Case Holder we offer both New Case, for Full Length Sized/New Brass and FIRED for Neck Sized Only Brass.
Q: Which holder should I buy for 7mm Mauser (7x57)?
That would be the 257 Robert Case Holder. Part # CH-257R. Select 7mm then select 6mm / 244 Remington -257 Roberts - 7mm Mauser