10% off all products for online orders. Price reflected in cart. (excluding presses)

For Accurate Uniform Handloads, Since 1927

0Item(s)
0 Items View Cart

You have no items in your shopping cart.

Product was successfully added to your shopping cart.

Case Holders

Set Descending Direction

   

4 Item(s)

  1. Pistol Holders

    These hardened holders (for fired cases only) are stocked in .38 Special, .38 Super Auto, .357 Magnum, .44 Russian, .44 Special, .44 Magnum, 40 S&W, .45 Auto, .45 Colt and 10mm. All these cases have practically no body taper and require a special type holder, which is constructed very much like a neck sizing die.

    Cases can’t be “bumped” in and out of these holders like most rifle cases but must be forced in with a light arbor press or mallet and must be driven or pushed out.

    These holders are made longer than the cases to be trimmed so that cases may be forced clear in without damage to case mouth. Holders are counterbored at mouth end for cutter clearance. Users will find the case trimmer somewhat slower on pistol cases than on rifle cases but it will produce a very uniform case length with consequent perfection in crimping.

    INSTRUCTIONS

  2. Q-Type Case Holder

    Case Holders allow you to trim cases in your Wilson Case Trimmer. The Q-Type case holders hold the case with an easy to use cross pin. Use this type whenever possible because the regular pistol case holders require you to tap the pistol case in, which is more difficult than the rifle cases because of the lack of a body taper.

    Not compatible with the Sinclair "Sharkfin" or the L.E. Wilson Case Holder Clamp

    INSTRUCTIONS

  3. Rifle Case Holders

    The case holder holds the case for trimming, primer pocket reaming, neck reaming and deburring with our Uniform Deburring Tool. The L.E. Wilson Trimmer Case Holder provides the ultimate accuracy and uniformity for trimming your cases. The unique design of the case holder supports the case body, much like a chamber of a firearm. The Case Holders are precisely manufactured for consistent results and repeatability.

    * The FIRED Case Holders are for Neck Sized Cases. * But, if we DO NOT make a "New Case" holder for your caliber then this will work for all cases (NEW, FIRED OR FULL LENGTH RESIZED).

    ** For example: we only make ONE holder for the 222/223 Remington. This will work for all Fired / New and Full Length Resized Brass **

    INSTRUCTIONS

  4. Rifle Case Holders - NEW CASE

    The case holder holds the case for trimming, primer pocket reaming, neck reaming and deburring with our Uniform Deburring Tool. The L.E. Wilson Trimmer Case Holder provides the ultimate accuracy and uniformity for trimming your cases. The unique design of the case holder supports the case body, much like a chamber of a firearm. The Case Holders are precisely manufactured for consistent results and repeatability.

    ** If we make a NEW Case Holder, it is for full length resized or new brass. **

    ***If we do not stock a NEW Case Holder then all you will need is the Standard Fired version. ***

    INSTRUCTIONS

Set Descending Direction

   

4 Item(s)